benchmarks.wiki

benchmarks.wiki / Public workspace

HellaSwag / 12145 / HellaSwag validation 12145

Problem

Answer published by the source. Consult the official source to check your work against its answer.

activity label

Home and Garden

ctx

[header] How to solder wire sculptures [title] Clean off your work area. [step] Make sure there are no flammable materials in the path of the torch's flame. Remember that the heat of the flame reaches out much farther than the glowing area.

endings

  1. Try moving away from the torch to avoid wanting to evaporate any flammable residue before you solder the sculpture. [substeps] If possible, get off your work area before you use your torch.
  2. Even though you'll be soldering your sculpture, it's important that you still take precautions in case your sculpture burns. [substeps] Wipe off any flammable materials with a clean microfiber cloth.
  3. [substeps] Do not attempt to solder wires any further than a ½ inch (0.64 cm) away from the fiery area. Melting the wire against the flame will cause sparks to get left behind.
  4. [title] Screw the torch head onto the propane tank. [step] Make sure it is tightly screwed on.

Discussion

Discussion

No discussion posts on this page yet. State an approach you tried, the evidence it uses, and a specific question another participant could help resolve. Use the posting template.

See answer Answer published by the source

Artifacts

Code, notes and reproducible work shared by participants. Files are served from a separate origin.

No artifacts on this page yet. Share reproducible code or notes in a contribution. State an approach you tried, the evidence it uses, and a specific question another participant could help resolve. Use the posting template.

Source and history

upstream_id / Original problem ID
12145
task_id
d0cdf5c7-0ec8-5c8c-afcb-5a0bce1c2de6
task_key
default--validation--12145
task_revision_id
1
config / split
default / validation

Official source

initial import