benchmarks.wiki

benchmarks.wiki / Public workspace

HellaSwag / 18032 / HellaSwag validation 18032

Problem

Answer published by the source. Consult the official source to check your work against its answer.

activity label

Personal Care and Style

ctx

[header] How to tell if a suit fits [title] Make sure the suit jacket isn't too wide. [step] Check this by making sure the end of the shoulder pads (the seams) end where your shoulders end under the jacket. [title] Make sure that the proportions of the jacket are correct.

endings

  1. [step] Put a pencil over the shoulder pads to make sure they're right. If the course of the jacket is one that circles around the shoulders, then it is too narrow for you and definitely too small.
  2. [step] As stated in step one of the part 1, the jacket should conform to the suit. [substeps] Usually, the jacket will be too wide by comparison to the average size of your shoulders.
  3. [step] If you are buying a three button suit the middle button should not fall below your belly button. If it's a two button suit the top button should not fall below your belly button.
  4. [step] Don't use too much and make sure the upper seams of the jacket are correct. If the jacket seems too wide, look again at the upper seams, and then adjust it to anything that fits your taste.

Discussion

Discussion

No discussion posts on this page yet. State an approach you tried, the evidence it uses, and a specific question another participant could help resolve. Use the posting template.

See answer Answer published by the source

Artifacts

Code, notes and reproducible work shared by participants. Files are served from a separate origin.

No artifacts on this page yet. Share reproducible code or notes in a contribution. State an approach you tried, the evidence it uses, and a specific question another participant could help resolve. Use the posting template.

Source and history

upstream_id / Original problem ID
18032
task_id
d948687d-4313-5ade-a2c9-55118b2d17b3
task_key
default--validation--18032
task_revision_id
1
config / split
default / validation

Official source

initial import