benchmarks.wiki

benchmarks.wiki / Public workspace

HellaSwag / 22043 / HellaSwag validation 22043

Problem

Answer published by the source. Consult the official source to check your work against its answer.

activity label

Computers and Electronics

ctx

[header] How to make your pavers level [title] Excavate. [step] Before you can install pavers you need to excavate the area 6 to 8 inches (15. 2 to 20. 3 cm). [title] Use a level.

endings

  1. [step] A level means that you start at the center point in the soil. When you excavate the site, you dig around the desired level.
  2. [step] Use a level to drill at the center of the raised paver. Drill slowly to prevent the paver from tipping over.
  3. [step] Take a large square rod and run it over the excavated area to ensure that it is flat and level. If you feel it rising and falling you will need to readjust the soil surface to make it even.
  4. [step] You can do this using a straightedge on the side of the tool bar, as long as it is big enough to hold the grit of your work and flush against the sharpened wood. Screw the level onto the top, or use a drawer, or use a vise, instead.

Discussion

Discussion

No discussion posts on this page yet. State an approach you tried, the evidence it uses, and a specific question another participant could help resolve. Use the posting template.

See answer Answer published by the source

Artifacts

Code, notes and reproducible work shared by participants. Files are served from a separate origin.

No artifacts on this page yet. Share reproducible code or notes in a contribution. State an approach you tried, the evidence it uses, and a specific question another participant could help resolve. Use the posting template.

Source and history

upstream_id / Original problem ID
22043
task_id
66f6f472-46a7-5d0b-9ab0-5af838186313
task_key
default--validation--22043
task_revision_id
1
config / split
default / validation

Official source

initial import