benchmarks.wiki

benchmarks.wiki / Public workspace

HellaSwag / 32586 / HellaSwag validation 32586

Problem

Answer published by the source. Consult the official source to check your work against its answer.

activity label

Sports and Fitness

ctx

[header] How to belay [title] Make a loop in one end of the climbing rope. [step] Most professional climbers recommend tying in the climber with a figure 8 follow through knot. Start by making a loop, or bight, about three feet (one meter) from the end of the rope.

endings

  1. [title] Bend the tail around the rope below the loop. [step] While holding the loop you have just made, pass the tail of the rope around the front of the main strand a little bit below the bottom of the loop.
  2. [substeps] Check that there is enough rope left in the loop to tie off the climber. If there is not enough rope left, leave about six inches between the knot and the rope.
  3. [substeps] Remove your foot from the loop at this point to loosen the belay attachment. Start fishing your foot out from the loop.
  4. You can make a wide loop in this loop, or create a narrower loop by tying a cord or a lever in the loop. [substeps] Make the knot about three inches (five centimeters) from the end of the rope, so that you can continue jumping.

Discussion

Discussion

No discussion posts on this page yet. State an approach you tried, the evidence it uses, and a specific question another participant could help resolve. Use the posting template.

See answer Answer published by the source

Artifacts

Code, notes and reproducible work shared by participants. Files are served from a separate origin.

No artifacts on this page yet. Share reproducible code or notes in a contribution. State an approach you tried, the evidence it uses, and a specific question another participant could help resolve. Use the posting template.

Source and history

upstream_id / Original problem ID
32586
task_id
84a29ba3-4e72-5e59-889f-177efda5fcb1
task_key
default--validation--32586
task_revision_id
1
config / split
default / validation

Official source

initial import