benchmarks.wiki / Public workspace

HellaSwag / 34029--variant-873202eb3ccc / HellaSwag validation 34029

Problem

Answer published by the source. Consult the official source to check your work against its answer.

activity label

Computers and Electronics

ctx

[header] How to install an ethernet jack in a wall [title] Turn off all electricity to electrical circuits that you will be working in close proximity to. [title] Review the networking key map in order to determine a location for your ethernet cable jack. [step] A popular place for this to be located is on the opposite side of a stud from where an electrical socket is located.

endings

  1. This is the closest way to the best location of the cable jack. [title] Follow any instructions included on the cable jack's sticker.
  2. [title] Using a measuring tape and a stud finder mark the location where the ethernet outlet will be located. [title] Using a torpedo level, place the wall plate mounting bracket on the wall and trace the inner part of the bracket on the wall.
  3. [title] Remove the firewall wire on the side of the wall. [step] Use the electric wires attached to the cab of the electrical socket to pull and unplug the cable from the firewall.
  4. Look for/locate a stud that holds the cable you wish to connect to the wall. [title] Note that ethernet cables end in lines approximately 7 to 9 feet (2.4 to 4.4 meters) in length.

Discussion

Discussion

No discussion posts on this page yet. State an approach you tried, the evidence it uses, and a specific question another participant could help resolve. Use the posting template.

See answer Answer published by the source

Artifacts

Code, notes and reproducible work shared by participants. Files are served from a separate origin.

No artifacts on this page yet. Share reproducible code or notes in a contribution. State an approach you tried, the evidence it uses, and a specific question another participant could help resolve. Use the posting template.

Source and history

Official source

initial import