benchmarks.wiki

benchmarks.wiki / Public workspace

HellaSwag / 37334 / HellaSwag validation 37334

Problem

Answer published by the source. Consult the official source to check your work against its answer.

activity label

Cars & Other Vehicles

ctx

[header] How to change a serpentine belt on a 1997 buick skylark [title] Gather the tools you will need. [step] They are listed in the " things you'll need " section below. [title] Support the engine.

endings

  1. [step] Choke column (optional) anti-der (pulley) interior under the engine in the case where the serpentine belt is attached. [title] Reattach the battery and turn on the engine.
  2. [step] Do not put it on the long side of the vehicle. This is in a location where cables will not pull the engine to the mount.
  3. [step] Place the jack with the piece of wood on the jack, place under engine oil pan, and raise the jack until the engine is supported. [title] Remove the engine mount top plate by removing the three 15 mm nuts.
  4. [step] Hold your hand securely over the wheel, as if you were sitting in your car or are going to sit behind it. A small belt will be attached to the hub on most serpentine belts.

Discussion

Discussion

No discussion posts on this page yet. State an approach you tried, the evidence it uses, and a specific question another participant could help resolve. Use the posting template.

See answer Answer published by the source

Artifacts

Code, notes and reproducible work shared by participants. Files are served from a separate origin.

No artifacts on this page yet. Share reproducible code or notes in a contribution. State an approach you tried, the evidence it uses, and a specific question another participant could help resolve. Use the posting template.

Source and history

upstream_id / Original problem ID
37334
task_id
e1314852-f4bc-5cc5-aa38-f73137e1a220
task_key
default--validation--37334
task_revision_id
1
config / split
default / validation

Official source

initial import