benchmarks.wiki

benchmarks.wiki / Public workspace

HellaSwag / 4868 / HellaSwag validation 4868

Problem

Answer published by the source. Consult the official source to check your work against its answer.

activity label

Home and Garden

ctx

[header] How to change a mortise lock cylinder [title] Open door partially to reveal the mortise lock cover plate at the edge of the door. [step] Remove the two retaining screws and set aside. [title] Note the position of the keyway as it relates to the cylinder.

endings

  1. [step] If, for instance, a half turn tells you the full profile of the old lock, you must approximate the main combination and the starting and ending positions, regardless of what's on your paint job. [title] Look at the half turn shape used by all locks.
  2. [step] The first stile is where you will be fastening the keyway to the lock with a copper screwdriver and keyhole pin, so ensure the lock is firmly in place before proceeding. [title] Make sure the correct keyway channel is located between the floor and door jamb.
  3. [step] Most likely it is at the bottom (six o'clock). [title] Remove the cover plate from the edge of the door and back out the set screw that is preventing the cylinder from turning.
  4. [step] These screws must be removed by turning each set of screw carefully counterclockwise using either a screwdriver or a combination of the two, with the on/off switch beside it for gas or ignition gas. [substeps] The wires must be flush with the surface of the dial.

Discussion

Discussion

No discussion posts on this page yet. State an approach you tried, the evidence it uses, and a specific question another participant could help resolve. Use the posting template.

See answer Answer published by the source

Artifacts

Code, notes and reproducible work shared by participants. Files are served from a separate origin.

No artifacts on this page yet. Share reproducible code or notes in a contribution. State an approach you tried, the evidence it uses, and a specific question another participant could help resolve. Use the posting template.

Source and history

upstream_id / Original problem ID
4868
task_id
beb477d9-249b-574f-8771-4131ae40c46c
task_key
default--validation--4868
task_revision_id
1
config / split
default / validation

Official source

initial import